To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Electric Mr. Slim PLH-1.6KKB and is the answer not in the manual?
General| Category | Air Conditioner |
|---|---|
| Cooling Capacity | 1.6 kW |
| Heating Capacity | 1.8 kW |
| Power Supply | 220-240 V, 50 Hz |
| Indoor Unit Weight | 9 kg |
| Model | PLH-1.6KKB |
Provides outline dimensions for the indoor unit, including width, depth, and height.
Provides outline dimensions for the outdoor unit, including width, depth, height, and mounting related dimensions.
Details maximum pipe length, height difference, and number of bends for refrigerant pipes.
Specifies required clearance around the outdoor unit for ventilation and service access.
Lists and describes the accessories included with the indoor unit for installation.
Details how to prepare the ceiling opening and locate suspension bolt points for indoor unit installation.
Provides guidance on creating a strong structure for suspending the indoor unit, considering different building types.
Outlines the step-by-step procedure for suspending the indoor unit using bolts and plates.
Details requirements for the foundation, including bolt size, concrete thickness, and load capacity.
Specifies requirements for refrigerant and drainage piping for the indoor unit, including material and insulation.
Illustrates the placement and dimensions for refrigerant and drainage pipes relative to the unit and ceiling.
Details the process of connecting refrigerant pipes, including oil application, tightening, purging, and leak detection.
Explains the correct procedure for operating the stop valve on the outdoor unit before, during, and after refrigerant tubing connections.
Provides instructions and a table for adding refrigerant based on pipe length and model.
Details how to install the drain pipe, including slope, joint adhesive, and hose insulation.
Outlines essential safety precautions and requirements for electrical wiring.
Provides instructions for wiring the indoor unit, including removing service panels and connecting cables.
Explains how to select a mounting position and install the remote controller.
Details how to set DIP switches for remote control address and function configuration.
Explains how to use a single remote controller for multiple units and set up group control.
Lists essential checks to perform before starting the test run, including leak checks and electrical safety.
Provides step-by-step instructions for operating the unit during the test run, including power, button operations, and checks.
Explains how to interpret LED indicators on the indoor unit board for self-diagnosis and error codes.
Details the procedure for checking proper water drainage and preventing leaks during the test run.
Lists the parts included in the grille installation kit.
Explains how to prepare the ceiling opening and check clearances for grille installation.
Details the procedure for removing and installing the intake grille, including safety chain attachment.
Guides the user on selecting the correct air outlet direction pattern and setting DIP switches.
