Mitsubishi Electric Mr. SLIM User Manual

Air-Conditioners
SL(H)-1, 1.6, 2AR
INSTALLATION MANUAL
For safe and correct use, please read this installation manual thoroughly before installing the air-conditioner unit.
INSTALLATIONSHANDBUCH
Zum sicheren und ordnungsgemäßen Gebrauch der Klimaanlage das Installationshandbuch gründlich durchlesen.
MANUEL D’INSTALLATION
Veuillez lire le manuel d’installation en entier avant d’installer ce climatiseur pour éviter tout accident et vous assurer d’une utilisation correcte.
MANUAL DE INSTALACIÓN
Para un uso seguro y correcto, lea detalladamente este manual de instalación antes de montar la unidad de aire acondicionado.
MANUAL DE INSTALAÇÃO
Para segurança e utilização correctas, leia atentamente este manual de instalação antes de instalar a unidade de ar condicionado.
MANUALE DI INSTALLAZIONE
Per un uso sicuro e corretto, leggere attentamente questo manuale di installazione prima di installare il condizionatore d’aria.
E
D
F
FOR INSTALLER
FÜR INSTALLATEURE
POUR L’INSTALLATEUR
PARA EL INSTALADOR
PARA O INSTALADOR
PER L’INSTALLATORE
ES
PR
I
Back to Index

Mitsubishi Electric Mr. SLIM Specifications

General

Type	Split System
Inverter Technology	Yes
Refrigerant	R-410A
Indoor Unit Noise Level	19 dB (varies by model)
Indoor Unit Dimensions	Varies by model
Outdoor Unit Dimensions	Varies by model
Energy Efficiency Ratio (EER)	Varies by model
Coefficient of Performance (COP)	Varies by model
Noise Level	Varies by model
Indoor Unit Weight	Varies by model
Outdoor Unit Weight	Varies by model
Features	Quiet Mode

Summary

Safety Precautions

General Safety Guidelines

General safety guidelines that must always be followed before installation.

Indoor Unit Installation

Refrigerant Piping Work

5.1. Refrigerant Pipe Specifications

5.2. Flaring Work

Explains the correct procedure for flaring copper tubes to prevent gas leaks.

5.4. Pipe Connection

Details how to connect refrigerant pipes, including oiling, purging, and insulation.

5.5. Purging Procedures Leak Test

Explains the procedures for purging air and performing a leak test on the refrigerant piping.

Drainage Piping Work

6.1. Drainage Piping Work

Guides on installing drainage piping, including pipe selection, slope, and connections.

Electrical Work

7.1. Power Supply Requirements

Specifies power supply requirements, including voltage, frequency, and circuit protection.

7.2. Indoor Unit Wiring

Provides step-by-step instructions for wiring the indoor unit, including component cover removal.

7.3. Outdoor Unit Connections

Installing the Grille

8.4. Wire Connection

Installing the Remote Controller

Test Run

10.1. Before Test Run

Covers pre-test run checks, including refrigerant leaks, connections, polarity, and impedance measurement.

10.2. Auto Restart Function Setup

10.3. Test Run Procedures

Details the steps for performing the test run, including impedance checks and using the emergency operation switch.

10.4. Drainage Check

Guides on checking for proper water drainage and ensuring no leaks during the test run.

Maintenance

11.1. Gas Charge

Explains how to charge refrigerant gas, including cylinder connection, air purge, and safety precautions.