To Next PageTo Next PageWhat to do if the indoor fan motor of my Mitsubishi Electric MU-09NV - E2 isn't working?
If the indoor fan motor isn't working, try the following: First, disconnect connector CN211 and check connector CN121 2 - 3 to ensure a rotational frequency feedback signal of 1.5V or higher exists. Then, check the indoor fan motor itself and the indoor electronic control P.C. board. Finally, ensure the connector is securely reconnected.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | MU-09NV - E2 |
| Category | Air Conditioner |
| Language | English |
Identifies and illustrates components of the indoor unit.
Identifies and illustrates components of the outdoor unit.
Details the remote controller buttons and their functions for operation.
Provides dimensions and installation details for the indoor unit.
Provides dimensions and installation details for the outdoor unit.
Shows the wiring diagram for the indoor unit.
Shows the wiring diagram for the outdoor unit.
Illustrates the refrigerant system for the indoor unit.
Illustrates the refrigerant system for the outdoor unit.
Details maximum refrigerant piping lengths and height differences.
Provides guidelines for additional refrigerant charge based on piping length.
Details the steps for evacuating the system and performing air purging.
Lists voltage, airflow, and main readings for performance curve analysis.
Step-by-step guide for measuring indoor air wet-bulb temperature difference.
Explains how to use the "I FEEL CONTROL" mode via the remote.
Details how initial set temperature is determined by room temperature.
Explains the function of TEMPERATURES buttons and fuzzy control.
Describes the operation and coil frost prevention in COOL mode.
Describes the operation in DRY mode for humidity control.
Details the steps for COOL mode operation.
Details the steps for DRY mode operation.
Explains how to operate the unit in FAN mode.
Describes the fan motor control mechanism and protection.
Explains the auto vane operation and its settings.
Describes vane positioning and AUTO mode for optimal temperature distribution.
Explains dew prevention and SWING mode features.
Describes the SLEEP mode for quiet operation and reduced airflow.
Details how to set and cancel timer operations.
Explains how to shorten timer settings for service purposes.
Details P.C. board modification for multi-unit remote control.
Lists precautions, general procedures, and battery replacement for troubleshooting.
Provides a troubleshooting flowchart, check table, and instructions for diagnosing issues.
Lists criteria and methods to check main parts for faults.
Detailed guides for checking specific components like fan motor, receiver, and boards.
Instructions for disassembling the indoor unit for specific models.
Instructions for disassembling the indoor unit for specific models.
Instructions for disassembling the outdoor unit for specific models.
Instructions for disassembling the outdoor unit for specific models.
Lists structural and heat exchanger parts for indoor units.
Lists electrical parts for indoor units.
Lists structural and electrical parts for outdoor units.
Lists structural and electrical parts for outdoor units (MU-12NV models).
Lists structural, heat exchanger, and electrical parts for indoor units.
Lists structural and electrical parts for outdoor units.
Details optional refrigerant pipes and their specifications.
Describes the deodorizing filter, its function, and maintenance.
