To Next PageTo Next PageWhat to do if my Mitsubishi Electric CITY MULTI PWFY-EP100VM-E2-AU runs briefly, but soon stops?
If your Mitsubishi Electric Air Conditioner starts but stops quickly, the issue might be obstructions at the air inlet or outlet of the indoor and outdoor units. Remove any obstacles and rerun the system. Another cause could be a strainer filled with dust and dirt. Clean the strainer and then rerun the air conditioner.
What to do if my Mitsubishi Electric CITY MULTI PWFY-EP100VM-E2-AU Air Conditioner does not run?
If your Mitsubishi Electric Air Conditioner isn't running, check the following: * **Power failure:** Press the [ON/OFF] button after power restoration. * **Power supply:** Ensure the power supply is turned ON. * **Fuse:** Replace the fuse if it's blown. * **Earth leakage breaker:** Put in the earth leakage breaker if it's gone.
What to do if my Mitsubishi Electric CITY MULTI PWFY-EP100VM-E2-AU has water out but it does not cool enough or heat enough?
If your Mitsubishi Electric Air Conditioner is outputting water but not cooling or heating adequately, the temperature adjustment may be improper. Check the set temperature and inlet temperature on the liquid crystal display, then refer to [Water temperature adjustment] and use the adjustment button.
General| Model | PWFY-EP100VM-E2-AU |
|---|---|
| Category | Air Conditioner |
| Series | CITY MULTI |
| Cooling Capacity | 10.0 kW |
| Heating Capacity | 11.2 kW |
| Power Supply | 220-240 V, 50 Hz |
| Refrigerant | R410A |
Details safety guidelines related to the unit's installation process.
Provides safety precautions to follow while the unit is operating.
Guidelines for safely and environmentally disposing of the air conditioner.
Guide on starting, stopping, changing modes, and adjusting water temperature.
Instructions for periods of non-operation and seasonal storage.
Allows selection of the display language for the remote controller.
Configure operation lock, mode skip, and temperature range limits.
Set controller roles, clock use, timer type, and contact numbers.
Configure temperature units (°C/°F) and water temperature display.
Instructions for cleaning the air conditioner strainer and its components.
Guides on diagnosing and resolving common operational problems.
Guidelines for selecting an appropriate and safe location for installation.
Safety precautions and requirements for electrical work during installation.
Recommendations for proper water pipe installation.
Procedures and precautions for moving or reinstalling the unit.
Considerations for minimizing noise and vibration during installation.
