To Next PageTo Next PageWhy my Mitsubishi Electric CITY MULTI PWFY-P100VM-E-BU does not run?
If your Mitsubishi Electric Air Conditioner doesn't run, it could be due to several reasons: * A power failure: After the power is restored, press the [ON/OFF] button. * The power supply is turned OFF: Turn the power supply ON. * The fuse in the power supply is gone: Replace the fuse. * The earth leakage breaker is gone: Put in the earth leakage breaker.
What to do if my Mitsubishi Electric CITY MULTI PWFY-P100VM-E-BU runs briefly, but soon stops?
If your Mitsubishi Electric Air Conditioner starts but stops quickly, the issue might be obstructions at the air inlet or outlet of the indoor and outdoor units. Remove any obstacles and rerun the system. Another cause could be a strainer filled with dust and dirt. Clean the strainer and then rerun the air conditioner.
What to do if my Mitsubishi Electric Air Conditioner does not run?
If your Mitsubishi Electric Air Conditioner isn't running, check the following: * **Power failure:** Press the [ON/OFF] button after power restoration. * **Power supply:** Ensure the power supply is turned ON. * **Fuse:** Replace the fuse if it's blown. * **Earth leakage breaker:** Put in the earth leakage breaker if it's gone.
What to do if Mitsubishi Electric Air Conditioner runs briefly, but soon stops?
If your Mitsubishi Electric Air Conditioner runs briefly and then stops, it might be due to these reasons: * Obstacles at the air inlet and outlet of the indoor and outdoor units: Remove the obstacles and rerun the system. * The strainer is filled with dust and dirt: Clean the strainer and rerun the system.
What to do if my Mitsubishi Electric CITY MULTI PWFY-P100VM-E-BU Air Conditioner has water out but it does not cool enough or heat enough?
If your Mitsubishi Electric Air Conditioner is outputting water but not cooling or heating adequately, the temperature adjustment may be improper. Check the set temperature and inlet temperature on the liquid crystal display, then refer to [Water temperature adjustment] and use the adjustment button.
General| Model | PWFY-P100VM-E-BU |
|---|---|
| Category | Air Conditioner |
| Heating Capacity | 11.2 kW |
| Power Supply | 220-240 V, 50 Hz |
| Refrigerant | R410A |
| Operating Temperature (Heating) | -15°C to 24°C |
Precautions for safe and correct installation of the unit.
Precautions to observe while the unit is operating.
How to Start, Stop, Change the Mode, and Adjust the Water Temperature.
How to adjust the water temperature setting on the remote controller.
Instructions for setting the current day and time on the remote controller.
Overview of timer functions available on the remote controller.
Detailed steps for configuring the weekly timer function.
A guide to check common issues before calling for service.
Guidelines for selecting a suitable installation location for the unit.
Precautions and requirements for electrical installation.
