To Next PageTo Next PageWhy does my Mitsubishi Electric PEAD-M35 cause an unpleasant odor in the room?
If your room has an unpleasant odor when using your Mitsubishi Electric Air Conditioner, the indoor unit may be drawing in air containing gases from walls, carpeting, and furniture, as well as odors trapped in clothing, and then blowing this air back into the room.
Why does Mitsubishi Electric PEAD-M35 stop before reaching set temperature in heating mode?
If your Mitsubishi Electric Air Conditioner stops before reaching the set temperature during heating mode, this may be because frost is forming on the outdoor unit due to low outdoor temperatures and high humidity. Normal operation should resume after approximately 10 minutes.
What to do if Mitsubishi Electric PEAD-M35 Air Conditioner does not restart immediately?
If your Mitsubishi Electric Air Conditioner doesn't restart immediately after being turned off, even when pressing the ON/OFF button, wait approximately three minutes before attempting to restart it.
Why does my Mitsubishi Electric Air Conditioner make a flowing water or hissing sound?
The flowing water or hissing sound you hear in your Mitsubishi Electric Air Conditioner is normal. These sounds occur when refrigerant is flowing within the system or when the refrigerant flow changes.
Why is water or vapor emitted from Mitsubishi Electric PEAD-M35 Air Conditioner outdoor unit?
If you observe water or vapor coming from the outdoor unit of your Mitsubishi Electric Air Conditioner, during cooling mode, water may form and drip from the cool pipes and joints. During heating mode, water may form and drip from the heat exchanger. Also, during defrosting mode, water on the heat exchanger evaporates and water vapor may be emitted.
Why is white mist emitted from Mitsubishi Electric PEAD-M35 indoor unit?
If you notice a white mist or vapor coming from the indoor unit of your Mitsubishi Electric Air Conditioner, this may occur when operation starts if the indoor temperature and humidity are high. This can also happen during defrosting mode, where cool airflow may appear like a mist.
Why my Mitsubishi Electric PEAD-M35 stops without pressing the ON/OFF button?
If your Mitsubishi Electric Air Conditioner shuts down unexpectedly without pressing the ON/OFF button, examine whether the off timer is active. Also, determine if the air conditioner is connected to a central remote controller or if “ ” appears in the remote controller display.
Why my Mitsubishi Electric Air Conditioner operates without pressing the ON/OFF button?
If your Mitsubishi Electric Air Conditioner starts running without pressing the ON/OFF button, check if the on timer is set. Also, verify if the air conditioner is connected to a central remote controller or if “ ” appears in the remote controller display. Finally, ensure that the auto recovery feature from power failures has not been activated.
What to do if an error code appears on Mitsubishi Electric Air Conditioner remote controller?
If an error code appears on your Mitsubishi Electric Air Conditioner's remote controller display, this indicates that the protection devices have been activated to safeguard the unit. Do not attempt to repair the equipment yourself. Immediately turn off the power switch and consult your dealer. Provide the dealer with the model name and the error code displayed on the remote controller.
Why Mitsubishi Electric PEAD-M35 display messages do not appear when operation switch is turned ON?
If the display messages do not appear on your Mitsubishi Electric Air Conditioner even when the operation switch is turned ON (and the operation lamp does not light up), this could be due to: * Incorrect wiring between the indoor and outdoor units (incorrect polarity of S1, S2, S3). * A short in the remote controller wire. To fix this, please refer to the provided table for troubleshooting.
General| Series | PEAD |
|---|---|
| Cooling Capacity | 3.5 kW |
| Heating Capacity | 4.0 kW |
| Power Supply | 220-240 V |
| Coefficient of Performance (COP) | 3.8 |
| Refrigerant | R410A |
| Phase | Single |
| Airflow Rate | 16 m³/min |
