To Next PageTo Next PageWhat to do if there is wrong connection of the connector or contact failure in Mitsubishi Electric PKFY-P40VHM-E?
If you suspect a wrong connection of the connector or contact failure, disconnect the connector at the controller board and then check the continuity.
What to do if valve does not close completely in Mitsubishi Electric PKFY-P40VHM-E Air Conditioner?
If the valve does not close completely, and a large amount of refrigerant is leaked, exchange the linear expansion valve. However, if the leakage is small and not affecting normal operation, it is not necessary to exchange the linear expansion valve.
How to fix operation circuit failure of the micro processor in Mitsubishi Electric PKFY-P40VHM-E?
To address an operation circuit failure of the microprocessor: exchange the indoor controller board in case of drive circuit failure. Alternatively, disconnect the connector on the controller board, then connect an LED for checking. When power is turned on, pulse signals will be output for 10 seconds. If the LED does not light while the signals are output or keeps lighting even after the signals stop, there are likely defects in the operation circuit.
What to do in case of short or breakage of the motor coil of the linear expansion valve in Mitsubishi Electric PKFY-P40VHM-E Air Conditioner?
If there is a short or breakage of the motor coil of the linear expansion valve, exchange the linear expansion valve.
What to do if linear expansion valve mechanism is locked in Mitsubishi Electric PKFY-P40VHM-E?
If the linear expansion valve mechanism is locked, exchange the linear expansion valve.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | PKFY-P40VHM-E |
| Category | Air Conditioner |
| Language | English |
Diagram showing the components of the indoor unit.
Overview of the wireless remote controller and its display functions.
Detailed specifications for different PKFY models including capacity, power, and dimensions.
Guide on how to check specific parts like thermistors, motors, and valves.
Procedures for removing the lower side and front panel of the indoor unit.
