3. Screen Confi guration
<Screen Types>
For details on setting the language for the remote controller display, refer
to section 8. Function Selection.
The initial language setting is English.
Function Selection of remote controller:
Set the functions and ranges available to the
remote controller (timer functions, operating
restrictions, etc.)
Set Day/Time: Set the current day of the week or time.
Standard Control Screens:
View and set the air conditioning system’s op-
erating status
Timer Monitor: View the currently set timer (weekly timer,
simple timer, or Auto Off timer)
Timer Setup: Set the operation of any of the timers (weekly
timer, simple timer, or Auto Off timer).
<How to change the screen>
A : Hold down both the Mode button and the Timer On/Off button for 2
seconds.
B : Press the Timer Menu button.
C : Press the Mode (Return) button.
D : Press either of the Set Time buttons (
or ).
4. Setting the Day of the Week and Time
1. Press the or Set Time button 1
to show display 2.
2. Press the Timer On/Off (Set Day) button 9
to set the day.
* Each press advances the day shown at 3 :
Sun Mon ... Fri Sat.
3.
Press the appropriate Set Time button
1
as necessary to set the time.
* As you hold the button down, the time (at 4) will increment fi rst in
one-minute intervals, then in ten-minute intervals, and then in one-
hour intervals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
button 4
to lock in the values.
5. Operation
Time Setting
Note:
The day and time will not appear if clock use has been dis-
abled at Function Selection of remote controller.
5.1. Turning ON/OFF
<To Start Operation>
Press the ON/OFF button 1.
• The ON lamp 1 and the display area come on.
Note:
When the unit is restarted, initial settings are as follows.
Remote Controller settings
Mode Last operation mode
Temperature setting Last set temperature
Fan speed Last set fan speed
Airfl ow up/down Last setting
2
3
4
1
9
42
1
3
2
2
3
6
1
4
5
2
5
6
2
78 6
3
3
7
5
6
7
8
7
1
1
5
To Next Page
Loading...
Need help?
General
