52
3 INSTALLATION AND WIRING
3.3 Installation and Removal of SD Memory Card
• Follow the above procedures for installation or removal of SD memory card while Multiple CPU system
power supply is ON. Not following the procedures may damage the data on the SD memory card.
• When removing the SD memory card, if there is a function accessing the SD memory card, the CARD
READY LED turns OFF after accessing the SD memory card is completed. Thus the time it takes for the
CARD READY LED to turn OFF differs depending on the function.
• When "Memory card remove/attach prohibit (SM605)" is ON, the CARD READY LED does not turn OFF
when the SD memory card access control switch is pushed. When the CARD READY LED will not turn OFF,
turning ON "SD memory card forced disable instruction (SM606)" will force the stop of the SD memory card.
• If the SSCNET cable connected to CN2 of R64MTCPU/R32MTCPU prevents removal of the SD memory
card, turn the Multiple CPU system power supply OFF and remove the SSCNET cable before removing
the SD memory card.
To Next Page
Loading...
