6
en
3. Operation
3.3. Temperature setting
<Cool, Drying, Heat, and Auto (Single set point)>
Press the [F2] button to decrease the preset temperature, and press the
[F3] button to increase.
• Refer to the table on page 5 for the settable temperature range for dif-
ferent operation modes.
• Preset temperature range cannot be set for Fan/Ventilation operation.
• Preset temperature will be displayed either in Centigrade in 0.5- or
1-degree increments, or in Fahrenheit, depending on the indoor unit
model and the display mode setting on the remote controller.
<For IR wireless remote controller>
To decrease the room temperature:
Press button 3 to set the desired temperature.
The selected temperature is displayed.
To increase the room temperature:
Press button 3 to set the desired temperature.
The selected temperature is displayed.
Cool
Room
AutoSet temp.
Mode Temp. Fan
Fri
83
83
MENU
ON
OFF
RETURN
SELECT
HOLD
Operation mode
Room temperature (Refer to the Installation Manual.)
Navigating through the screens
• To return to the Main screen ...... [RETURN] button
VG79Y108H01_en.indd 6 2019/08/07 9:36:18
To Next Page
Loading...
Need help?
General
