Timer off setting
⚫ When the dehumidifier is running, press the [Timer key] to adjust
time from 0h to 24h, pressing the key once to increase the setting
time by 1h, after the setting time exceeds 24h, the figure returns
to 0 to start cycle. The Timer key can also be pressed all the time,
the time increases and changes circularly, when the set time
expires, the dehumidifier turns off automatically. After the setting
is completed, if the Timer key no action within 5s, the set time is
confirmed. In timer off state, the Timer icon is continuously on.
Timer on setting
⚫ When the dehumidifier is in standby state, the method for
adjustment of setting time by the [Timer key] is the same as
timer off. After the setting is completed, if the Timer key no
action within 5s, the set time is confirmed. In timer on state,
the Timer icon is continuously on, and the set time is displayed
on control panel.
AUTO mode
⚫ Select AUTO dehumidification, if the room humidity is 5% higher
than the set humidity, the compressor will starts and the fan will
run at the set speed. If the room humidity is lower than the set
humidity by 5%, then the compressor and fan will stop. If the
humidity of the room is between +5% and -5% of the set humidity,
the whole machine runs in the original operating state, and the
initial value of the set humidity is 50%.
CONTINUOUS mode
⚫ Select CONTINUOUS dehumidification, no matter how the relative
humidity in the room is, the compressor starts, the fan runs at
high speed in default, fan speed can be adjusted.
Function description
25
To Next Page
Loading...