Need help?Do you have a question about the Mitsubishi Heavy Industries SRC13CDV-1 and is the answer not in the manual?
General| Type | Split System |
|---|---|
| Cooling Capacity | 3.5 kW |
| Heating Capacity | 4.0 kW |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Energy Efficiency Ratio (EER) | 3.21 |
| Noise Level (Outdoor) | 50 dB(A) |
Details the design and components of the SRK series split and wall-mounted air conditioners.
Explains the nomenclature used for identifying different SRK series air conditioner models.
Provides detailed technical specifications for SRK10CDV-1 and SRC10CDV-1 models.
Provides detailed technical specifications for SRK13CDV-1 and SRC13CDV-1 models.
Provides detailed technical specifications for SRK13CDV-4 and SRC13CDV-4 models.
Defines the operational limits and restrictions for the air conditioning units.
Provides dimensional drawings and measurements for the indoor unit.
Provides dimensional drawings and measurements for the outdoor units.
Illustrates the refrigerant piping diagram for the SRK10CDV/13CDV models.
Provides charts for selecting unit capacity based on temperature and piping length.
Presents the electrical wiring diagram for SRK10CDV-1 and 10CDV-4 models.
Presents the electrical wiring diagram for SRK13CDV-1 and 13CDV-4 models.
Details the functions and buttons of the wireless remote controller for unit operation.
Explains unit indicators, back-up switch functionality, and power blackout auto restart.
Describes flap control modes (AUTO, Memory, Swing) and comfort timer settings.
Details cooling operation of major components and fan speed switching logic.
Explains DRY operation, de-humidifying operation blocks, and ECONO operation.
Covers automatic operation determination and setting adjustments via remote signals.
Details dew condensation prevention, frost prevention, and self-diagnosis functions.
Provides essential safety warnings and cautions for installation and handling of the unit.
Guidelines for choosing optimal indoor and outdoor unit installation locations.
Details limitations for piping length and vertical height differences between units.
Instructions for mounting the installation board and drilling holes for the indoor unit.
Details on preparing the indoor unit, mounting connecting wires, and forming pipes.
Instructions for installing the indoor unit onto the mounting plate and removing it.
Guidelines for stable installation of the outdoor unit and connecting wiring.
Preparation steps for connecting refrigerant piping, including removing and installing flared nuts.
Covers connection of refrigerant piping using torque wrench and air purging procedures.
Explains additional refrigerant charging based on piping length and insulation of connecting portions.
Procedures for conducting a trial run after confirming no gas leaks and proper operation.
Guidelines for installing and operating the wireless remote controller, including coverage distances.
Provides a flowchart for troubleshooting common issues before exchanging PCB.
Details self-diagnosis indications for indoor units, including error codes and potential defects.
Troubleshooting steps for abnormalities of the outdoor unit, indoor fan motor, and thermistors.
Troubleshooting procedures for unit malfunctions, lamp indicators, and fan/motor issues.
Troubleshooting chart for room temperature and heat exchanger thermistors, and common faults.
Explains the evacuation procedure for purging impurities from the refrigerant system.
Details refrigerant charging procedures, including purging air and checking levels.
Describes how to operate the air conditioner via power supply ON-OFF without the remote controller.
Introduction to the parts list, covering components and important notes.
List of components for the Panel & Fan Assembly of SRK10CDV-1,-4 models.
List of components for Heat Exch. & Control of SRK10CDV-1,-4 models.
To Next Page