To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Heavy Industries SRC35ZJ-SA and is the answer not in the manual?
General| Type | Split System |
|---|---|
| Cooling Capacity | 3.5 kW |
| Heating Capacity | 4.0 kW |
| Energy Efficiency Ratio (EER) | 3.21 |
| Power Supply | 220-240V, 50Hz |
| Indoor Unit Dimensions (W x H x D) | 845 x 275 x 228 mm |
| Outdoor Unit Dimensions (W x H x D) | 780 x 540 x 290 mm |
| Weight (Indoor Unit) | 10 kg |
| Refrigerant | R32 |
| Indoor Unit Weight | 10 kg |
| Energy Efficiency Ratio (Cooling) | 3.21 W/W |
| Energy Efficiency Ratio (Heating) | 3.61 W/W |
| Noise Level (Indoor Unit) | 21 dB(A) |
Dimensions and installation clearances for indoor units.
Dimensions and installation clearances for outdoor units.
Dimensions and specifications for remote controllers.
Electrical wiring diagrams for indoor units.
Electrical wiring diagrams for outdoor units.
Guidance on selecting the correct capacity based on operating conditions.
Guidelines and safety precautions for indoor unit installation.
Guidelines and safety precautions for outdoor unit installation.
Operation control details for SRK25 and 35ZJ-S models.
Operation control details for SRK20-35ZJX-S models.
Guides for diagnosing and resolving common operational issues and errors.
Table correlating error codes, symptoms, causes, and display indicators.
How to access and use the service mode for diagnostics.
Instructions for installing the optional wired remote controller.
Essential safety warnings and precautions for installation.
Guidelines for choosing the optimal and safe location for unit installation.
Detailed procedures for on-site refrigerant piping work.
Criteria for choosing an appropriate installation location.
Requirements for installation space around the unit.
Specific instructions for the physical installation of the unit.
Explanation of remote controller functions.
Protective function to prevent frost formation on the indoor heat exchanger.
Protective function for cooling operation due to high outdoor temperatures.
Control to prevent anomalous high pressure during cooling.
Protective function for cooling operation in low outdoor temperatures.
Protective function to prevent anomalous high pressure during heating.
Protective function to prevent overload operation during heating.
Protective function for heating operation in low outdoor temperatures.
Protection mechanism to prevent compressor damage from overheating.
Control to prevent overcurrent, protecting the inverter and compressor.
Protection mechanism to prevent overcurrent by cutting the inverter's current.
Function to detect and stop the unit in case of outdoor unit malfunctions.
Protection for the indoor fan motor against low-speed operation.
Protection against malfunctions caused by communication errors.
Protection against compressor rotor lock.
Protection for the outdoor fan motor against prolonged low-speed operation.
Controls for the outdoor fan speed at low ambient temperatures.
Table of error codes, stop codes, causes, and troubleshooting steps.
Inspection procedures for common sensor errors.
Troubleshooting steps for indoor fan motor errors.
Troubleshooting steps for outdoor fan motor errors.
Troubleshooting phenomena related to sensors in the indoor unit.
Steps to check the indoor PCB for proper operation.
Procedure for checking the indoor unit fan motor.
Procedure for inspecting the power transistor.
Procedure for checking the outdoor unit fan motor.
Procedure for inspecting the electronic expansion valve.
Instructions for installing the optional wired remote controller.
