To Next PageTo Next PageWhy is there no airflow when starting the heating operation on my Mitsubishi Heavy Industries SRK25ZJX-S Air Conditioner?
If there's no airflow when you start the heating operation on your Mitsubishi Heavy Industries Air Conditioner (and the RUN light blinks slowly), it's because the airflow has stopped to prevent cold air from blowing out until the indoor heat exchanger warms up. This may take 2 to 5 minutes due to the HOT KEEP program.
What is the “Shooooo” sound coming from my Mitsubishi Heavy Industries SRK25ZJX-S Air Conditioner?
The “Shooooo” sound from your Mitsubishi Heavy Industries Air Conditioner that is turned off is the sound when operation of another indoor unit is stopped.
How to improve cooling or heating in Mitsubishi Heavy Industries Air Conditioner?
If you experience poor cooling or heating with your Mitsubishi Heavy Industries Air Conditioner, make sure you've set the thermostat to a suitable temperature, the air filter is clean (not clogged), and that all doors and windows are closed.
Why Mitsubishi Heavy Industries SRK25ZJX-S is not blowing air when heating?
If the Mitsubishi Heavy Industries Air Conditioner airflow is not blown out when starting the HEATING operation and the RUN light blinks slowly (1.5 sec ON, 0.5 sec OFF), it is because airflow has stopped to prevent blowing out cold air until the indoor heat exchanger has warmed up. This may take 2 to 5 minutes due to the HOT KEEP program.
Why does my Mitsubishi Heavy Industries Air Conditioner not turn on immediately after turning off?
If the Mitsubishi Heavy Industries Air Conditioner unit doesn't restart immediately after you stop it (RUN light is on), it's because restart is blocked for 3 minutes to protect the unit. Please wait for three minutes.
What causes gurgling sound in Mitsubishi Heavy Industries SRK25ZJX-S?
If you hear a slight gurgling sound from your Mitsubishi Heavy Industries Air Conditioner, it is caused by refrigerating liquid moving within the unit.
Why is there no airflow when starting the heating on my Mitsubishi Heavy Industries SRK25ZJX-S Air Conditioner?
If airflow stops when starting the HEATING operation and the RUN light blinks slowly on your Mitsubishi Heavy Industries Air Conditioner, it's preventing cold air from blowing out until the indoor heat exchanger warms up, which takes about 2 to 5 minutes due to the HOT KEEP program.
Why won't my Mitsubishi Heavy Industries Air Conditioner restart immediately?
If your Mitsubishi Heavy Industries Air Conditioner doesn't restart right away after you turn it off (and the RUN light is on), please wait for three minutes. The microcomputer's three-minute protection timer will automatically start it again.
How to troubleshoot a Mitsubishi Heavy Industries Air Conditioner that won't turn on?
If your Mitsubishi Heavy Industries Air Conditioner is not working at all, check if the power switch is turned on, if the timer has been set in the “ON” position, and if there is a power failure or a blown fuse.
What to do if my Mitsubishi Heavy Industries Air Conditioner is not cooling effectively?
If your Mitsubishi Heavy Industries Air Conditioner isn't cooling well, check if direct sunlight is entering the room, if there's a heat source present, or if there are too many people in the room.
General| Cooling Capacity | 2.5 kW |
|---|---|
| Heating Capacity | 3.2 kW |
| Energy Efficiency Class Heating | A |
| Refrigerant | R32 |
| Indoor Unit Dimensions (W x H x D) | 798 x 294 x 229 mm |
| Outdoor Unit Dimensions (W x H x D) | 780 x 540 x 290 mm |
| Noise Level (Indoor Unit) | 21 dB |
| Power Supply | 220-240 V, 50 Hz |
