To Next PageTo Next PageWhy does my Mitsubishi Heavy Industries Air Conditioner blow cold air during heating?
When the outdoor temperature is low and humidity is high, your Mitsubishi Heavy Industries Air Conditioner may automatically defrost. Please wait for the defrosting cycle to complete.
Why is the remote control not working with my Mitsubishi Heavy Industries Air Conditioner?
If the signal receiver on your Mitsubishi Heavy Industries Air Conditioner is exposed to direct sunlight or other bright light, remote control signals may not be received. Try to block the sunlight or reduce the intensity of the other light source.
How to troubleshoot a Mitsubishi Heavy Industries SRK50ZJ-S Air Conditioner that won't turn on?
First, check if the power switch is turned on. Also, verify that the timer hasn't been set to the 'ON' position. Finally, check for a power failure or a blown fuse.
Why is my Mitsubishi Heavy Industries SRK50ZJ-S Air Conditioner not cooling or heating properly?
Make sure that you have set the thermostat to a suitable temperature. Check if the air filter is clean and not clogged. Ensure that all doors and windows are closed.
Why is there no airflow when I start the heating on my Mitsubishi Heavy Industries Air Conditioner?
When starting the heating operation, the airflow may be stopped temporarily to prevent cold air from blowing out until the indoor heat exchanger warms up. This usually takes 2 to 5 minutes, thanks to the HOT KEEP program.
Why won't my Mitsubishi Heavy Industries SRK50ZJ-S restart after a power outage?
If the auto restart function is not set on your Mitsubishi Heavy Industries Air Conditioner, the unit will not restart automatically after a power cut. Use the remote control to start the operation again.
What causes the slight cracking sound in my Mitsubishi Heavy Industries SRK50ZJ-S?
This slight cracking sound from your Mitsubishi Heavy Industries Air Conditioner is caused by heat expansion or contraction.
What is the slight gurgling sound from my Mitsubishi Heavy Industries SRK50ZJ-S Air Conditioner?
This sound is caused by refrigerating liquid moving within the Mitsubishi Heavy Industries Air Conditioner unit.
Why doesn't my Mitsubishi Heavy Industries Air Conditioner restart immediately after being stopped?
The Mitsubishi Heavy Industries Air Conditioner has a built-in delay. Restart is blocked for 3 minutes after you stop it to protect the unit. Please wait for three minutes before restarting.
Why does my Mitsubishi Heavy Industries SRK50ZJ-S have a slight smell?
The air blown out during operation of your Mitsubishi Heavy Industries Air Conditioner may have a slight smell. This can be caused by tobacco or cosmetics adhering to the unit.
General| Type | Split System |
|---|---|
| Cooling Capacity | 5.0 kW |
| Heating Capacity | 5.8 kW |
| Energy Efficiency Ratio (EER) | 3.21 |
| Coefficient of Performance (COP) | 3.61 |
| Energy Efficiency Rating (Cooling) | A++ |
| Power Supply | 220-240V, 50Hz |
| Outdoor Noise Level | 50 dB(A) |
| Indoor Noise Level | 28 dB(A) |
