EasyManuals Logo
Home>Mitsubishi>Automobile>2010 RVR

Mitsubishi 2010 RVR User Manual

Mitsubishi 2010 RVR
602 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #378 background imageLoading...
Page #378 background image
Comfort controls
5-9
5
N
OTE
While the mode selection dial is set between “ ” and
” position, the air conditioning compressor will run
automatically. The outside air position will also be
selected automatically. (In this case, the air conditioning
indicator will not change.)
When the temperature control dial is set to the “MAX
A/C” position, the air selection will be automatically set
to the recirculation position.
When the temperature control dial is in the “MAX A/C”
position, if it is set to a position other than “MAX A/C”,
the setting for the air selection switch is selected as
described below. The selection of recirculated air or out-
side air depends on the setting before “MAX A/C” was
used.
If automatic control was set:
Automatic control is continued
If recirculated air was selected:
Recirculated air is selected
If outside air was selected:
Outside air is continued
Personalizing the air selection (Changing the function
setting)
N00702100015
You can change the following functions to match your prefer-
ence.
Enable automatic air control:
When the air conditioning operates, the air selection
switch will be automatically controlled.
Disable automatic air control:
Even when the air conditioning operates, the air selection
switch will not be automatically controlled.
Changing the settings
Press the air selection switch for about 10 seconds or
longer.
When the setting has changed, the system will beep and
the indicator light will flash.
When the setting has changed from enabled to disabled,
the system will beep three times and the indicator will
flash three times.
When the setting has changed from disabled to enabled,
the system will beep two times and the indicator light
will flash three times.
N
OTE
The factory setting is “Enable automatic air control”.
While the mode selection dial is set between “ ” and
” position, the air selection will automatically change
to the outside air position, even if the system is set to
“Disable automatic air control”, in order to prevent win-
dows from fogging up.
BK0120400US.book 9 ペー 2010年5月12日 水曜日 午前10時50

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi 2010 RVR and is the answer not in the manual?

Mitsubishi 2010 RVR Specifications

General IconGeneral
BrandMitsubishi
Model2010 RVR
CategoryAutomobile
LanguageEnglish

Related product manuals