2-16
Seat and restraint systems
2
Folding the rear seatbacks forward
N00417800046
The passenger and luggage compartments can be joined by
folding the seatback forward. This is useful for carrying long
objects.
The seatbacks can be folded with the rear seat release button.
OTE
● You can separately fold the right and left side of the seat-
back.
To fold the seatbacks
Push the rear seat release button (A) to fold the seatback for-
ward.
The rear outboard seat belt can be separated from the seat belt
guide (B) to help prevent damage to the seat belt while the
seatback is folded.
To return the seatbacks
1. If the outboard seat belt has been separated from the seat
belt guide (B), insert it back into the seat belt guide.
2. Tilt the seatback up until it is locked properly in position.
Two seatback angles can be selected depending on return-
ing speed of the seatback. When the seatback is raised and
pushed backward slowly, the seatback angle will be set at
the more upright position.
OTE
● If the seat belt locks up and cannot be pulled out, pull it
once with force and let it retract all the way. Then, pull the
belt out slowly once again.
● To change the seatback angle, move the seatback forward
or backward while pressing the rear seat release button.
CAUTION
!
● Before folding the driver’s side rear seatback,
detach the center seat belt from the detachable
anchor and retract the center seat belt all the way to
the rear trim to prevent damage to the seat belt
caused by an object in the luggage compartment.
For details, refer to page 2-23.
BK0120400US.book 16 ページ ２０１０年５月１２日 水曜日 午前１０時５０分
To Next Page
Loading...
Need help?
General
