Seat and restraint systems
2-41
2
6. Remove the head restraint from the location in which you
wish to install a child restraint system.
7. Remove the cargo area cover from the vehicle. (Refer to
“Cargo area cover” on page 3-252.)
8. Latch the tether strap hook (A) of the child restraint sys-
tem to the tether anchor bar (B) and tighten the tether strap
so it is securely fastened.
9. Before putting your child in the restraint, push and pull
the restraint in all directions to be sure it is firmly secure.
Do this before each use. If the child restraint system is not
firmly secure, repeat steps 1 through 8.
10. To remove a child restraint system from the vehicle and
deactivate the ALR mode, remove the child from the
restraint. Unlatch the buckle. Then remove the belt from
the restraint and let the belt fully retract.
If your child restraint system requires the use of a tether strap,
fasten the tether strap in accordance with the following proce-
dures.
WARNING
!
● Child restraint system tether anchors are designed
only to withstand loads from correctly fitted child
restraint systems. Under no circumstances are they
to be used for adult seat belts, or harnesses, or for
attaching other items or equipment to the vehicle.
BK0120400US.book 41 ページ ２０１０年５月１２日 水曜日 午前１０時５０分
To Next Page
Loading...
Need help?
General
