Multi-information display
Features and controls 5-91
5
Shows the approximate driving range (how
many more miles or kilometers you can
drive). When this driving range falls below
30 miles (50 km), “---” is displayed.
Refuel as soon as possible.
This displays the average speed from the last
reset to the present.
There are 2 types of mode settings as follows.
For details on how to change the average
speed display setting, refer to “Changing the
function settings (With ignition switch or
operation mode in ON)” on page 5-98.
When the average speed is being dis-
played, if you hold down the multi-infor-
mation meter switch, these calculations
will be reset to zero.
When the following operation is per-
formed, the mode setting changes auto-
matically from manual to auto.
[Except for vehicles equipped with the
F.A.S.T.-key]
Turn the ignition switch to the “ON” posi-
tion from the “ACC” or “OFF” position.
[For vehicles equipped with the F.A.S.T.-
key]
Change the operation mode to ON from
ACC or OFF.
When the average speed is being dis-
played, if you hold down the multi-infor-
mation meter switch, these calculations
will be reset to zero.
If the engine is overheating, “ ” will blink.
In this case, the bar graph is on the red zone.
Immediately park the vehicle in a safe place
and take the required measures. Refer to
“Engine overheating” on page 8-4.
Driving range display
The driving range is determined based on the
fuel consumption data. This may vary
depending on the driving conditions and hab-
its. Treat the distance displayed as just a
rough guideline.
When you refuel, the driving range display is
updated.
However, if you only add a small amount of
fuel, the correct value will not be displayed.
Fill to a full tank whenever possible.
When your vehicle is stopped on an
extremely steep hill, the driving range value
may, change. This is due to the movement of
fuel in the tank and does not indicate any
breakdown.
The display setting can be changed to the
preferred units (miles or km).
Refer to “Changing the function settings
(With ignition switch or operation mode in
ON)” on page 5-98.
Average speed display
Manual reset mode
To Next Page
Loading...
