Theft-alarm system
5-34 Features and controls
5
Park the vehicle and stop the engine. Arm the
system as described below.
1. Except for vehicles equipped with the
F.A.S.T.-key, remove the key from the
ignition switch.
For vehicles equipped with the F.A.S.T.-
key, put the operation mode in OFF.
2. Make sure that the engine hood is closed.
3. Lock all doors and the liftgate by using
the keyless entry system or the F.A.S.T.-
key operation.
At this time, the theft-alarm indicator (A)
on the audio panel flashes for confirma-
tion.
4. The system has entered the armed stage
after about 20 seconds, when the theft-
alarm indicator (A) flashing becomes
slower.
The theft-alarm indicator (A) continues to
flash while the system is in the armed
stage.
If the engine hood is open, the theft-alarm
indicator (A) illuminates and the system can-
not enter the armed stage.
The system enters the armed stage about 20
seconds after the engine hood is closed.
The system will be disarmed if, while the
theft-alarm indicator (A) is illuminated, all
doors and the liftgate are unlocked by using
the keyless entry system or the F.A.S.T.-key
operation.
The system will be disarmed if, while the
theft-alarm indicator is illuminated, the fol-
lowing operation is performed.
• Except for vehicles equipped with the
F.A.S.T.-key, if the ignition switch is turned
to the “ON” position.
• For vehicles equipped with the F.A.S.T.-
key, if the operation mode is put in ON.
The system will not be armed if a door, the
liftgate or the engine hood is not completely
closed. If this happens, rearm the system as
described above.
BK0206700US.book 34 ページ ２０１４年３月２５日 火曜日 午後４時４２分
To Next Page
Loading...
