Mitsubishi 2016 OUTLANDER

12
1. Park your vehicle in a safe place and turn the ignition switch to
LOCK position.
2. Connect the cable

(cable is not included with the vehicle) to the
USB memory device

or the Dock connector

to the iPod

.
3. Open the cover

in the floor console box. Connect the cable  to
the USB input terminal

.
4. Turn the ignition switch to the “ACC” position. Turn on the audio
system.
5. Press MEDIA several times to switch to the USB mode. The input
mode changes as follows:
CD
 USB  Bluetooth
®
6. Depending on your USB device, it may take longer for playback to
start.
7. Once the device is selected, playback starts.
With Display Audio System, follow steps 1 through 4 above
5. Press MENU on the touch screen.
6. Touch USB.
7. Touch <Folder> then select a track and begin playback.
AUDIO SYSTEM
NOTE: Please refer to your Owner’s Manual for more
detailed information on how to use your audio
system.
USB and iPod Input







Audio Remote
Control Button
VOLUME
UP
VOLUME
Down
SEEK
Change
station
or track
MODE
Change
the
audio
source
C
D
B
A
To enter frequencies into the memory (AM/FM/SAT)
1. Press A to turn on the audio system.
2. Press B to select the desired band (AM/FM/SAT).
3. Press C to Seek Station
4. Hold down one of the Memory select buttons D
(1-6) until it beeps in order to save that station to
memory.
To adjust the clock
1. Press and hold the PAGE or MENU key and the
clock display flashes
2. Press the various buttons to adjust.
H- “Hour” setting
Press this key to fast-forward the “hours”
M- “Minutes” setting
Press this key to fast-foward the “minutes”
3. Press the PAGE or MENU key to finish adjusting the
time.
When the adjustment is completed, the clock
display stops flashing.