Need help?Do you have a question about the Mitsubishi 3000gt 1997 and is the answer not in the manual?
General| Brand | Mitsubishi |
|---|---|
| Model | 3000gt 1997 |
| Category | Automobile |
| Language | English |
Provides overall length, width, height, wheelbase, track, ground clearance, and overhangs.
Lists kerb weight, gross vehicle weight, and maximum axle weight.
Details engine model, displacement, transmission model, and type.
Details power supply and ignition switch connections for the fuel system.
Procedures for inspecting fuel system components while installed on the vehicle.
Information related to the fuel pump.
Describes changes made to the fuel system maintenance points.
Provides detailed specifications for the fuel system.
Inspection procedure for power supply and ignition switch related to MPI components.
Procedures for inspecting the vehicle's wiring harnesses.
Procedure for inspecting the control relay's continuity and functionality.
General steps for diagnosing issues within the service brakes system.
Details modifications made to the hydraulic unit, relays, G-sensor, and ABS-ECU.
Lists standard values for hydraulic unit resistance and G-sensor output voltage.
Lists special tools required for ABS and G-sensor checks.
Provides explanations for phenomena that may occur during ABS operation and are not abnormalities.
Procedures for checking diagnosis codes using MUT-II or without it.
Guides troubleshooting based on specific diagnosis codes for ABS malfunctions.
Troubleshooting for abnormal output signals from the wheel speed sensor.
Troubleshooting for issues with the ABS-ECU power supply voltage.
Troubleshooting for short circuits in wheel speed sensors.
Troubleshooting for G-sensor system faults, including open, short, or abnormal signals.
Troubleshooting for MUT-II communication failure with all systems.
Troubleshooting for MUT-II communication failure with SRS only.
Diagnosing why the ABS warning lamp does not illuminate when the ignition is on.
Diagnosing why the ABS warning lamp stays illuminated after the engine starts.
Reference table for data read by MUT-II from ABS-ECU input.
Procedure to check wheel speed sensor output voltage using a circuit tester or oscilloscope.
Guidelines for observing wheel speed sensor output voltage waveforms.
Checking the functionality of valve and motor relays for the ABS system.
Measuring resistance between terminals of solenoid valves in the hydraulic unit.
Verifying the sound of the hydraulic unit motor operating.
Instructions for connecting brake pipes to the hydraulic unit.
Procedure for inspecting G-sensor output voltage and functionality.
Important safety precautions to follow when servicing the SRS system.
Lists SRS components that should not be repaired, only replaced.
Guidance on replacing wiring harness connectors and wires for the SRS system.
Details the mapping between SRS-ECU terminals and harness connectors.
Important safety measures regarding battery disconnection before SRS work.
Lists special tools and test equipment used for SRS diagnostics.
General steps for diagnosing issues within the SRS system.
Detailed procedures for troubleshooting SRS based on specific diagnosis codes.
Troubleshooting for safing G-sensor circuit faults (short or open).
Troubleshooting for driver's side air bag module circuit issues (short, open, or connector faults).
Diagnosis for the SRS-ECU after an air bag deployment.
Troubleshooting for the IG1 (A) power circuit supplying voltage to the SRS-ECU.
Troubleshooting for SRS warning lamp circuit issues, including when it does not switch off.
Diagnosis for malfunctions in the SRS-ECU's non-volatile memory.
Troubleshooting for squib ignition drive circuits of driver's and passenger's side air bags.
Troubleshooting for MUT-II communication failure with all systems.
Troubleshooting for MUT-II communication failure with SRS only.
Detailed inspection steps for the clock spring, including continuity and visual checks.
To Next Page