Vehicle care and maintenance
7-13
7
Procedure for checking the fluid level
1. With the brake pedal fully depressed and the engine
idling, select each gear momentarily, ending with the
selector lever in the “P” (PARK) position.
2. The fluid level should be at the HOT mark, but never
above the HOT mark when the engine is warmed up. Add
or drain fluid to get to the correct level.
3. Make certain that the dipstick cap is installed properly to
keep dirt and water out of the transaxle.
Fluid type
Use only “DIAMOND ATF SP III” transaxle fluid to ensure
optimum transaxle performance.
Special additives
Mitsubishi Motors Corporation does not recommend the addi-
tion of any fluid additives to the transaxle.
WARNING
!
● Transaxle fluid is extremely flammable and poison-
ous. Do not spill fluid when adding or draining.
Good (Hot)
BK0115900US.book 13 ページ ２００９年１０月２７日 火曜日 午後１２時１分
To Next Page
Loading...
