Mitsubishi FDK15KXZE1 - Electrical Wiring

–
11
–
'17 • KX-T-264
4. ELECTRICAL WIRING
All models
Power source
220-240V 50Hz 220V 60Hz
1 Phase
Meaning of marks
i
1. indicates wiring on site.
2.Use twin core shielded cord
（0.75～1.25mm ） at signal line between
2
indoor unit and outdoor unit, and signal line between indoor units.
3.Use twin core cord
（0.3mm ） at remote control line.
2
See spec sheet of remote control in case that the total length is more than 100m.
4.Do not put signal line and remote control line alongside power source line.
Notes
5.Fuse
（F1）（※1）is 3.15A in case of FDK15-56 ,and 5A in case of FDK71, 90.
Thi-R1,2,3
Indication lamp（Green-Normal operation）LED・2
F1 Fuse FM
SW5 -1
Fan motor
Automatic adjustment／Fixed previous
SW3 Outdoor unit address:tens place SW4 Outdoor unit address:ones place
Item Description CNA-Z Connector HS Humidity sensor TB1 Terminal block（Power source）（□ mark） Thc Thi-A Thermistor（Return air）
Thermistor（Heat exchanger） Thermistor（Remote control）
TB2 Terminal block（Signal line）（□ mark） JSL1 Spare Superlink connector change LED・3 Indication lamp（Red-Inspection）
version of Superlink protocol
SW7 -1 Operation check
SW6, SW7-2
Model capacity setting
LM1 Flap motor
SW5 -2 Indoor unit address:hundreds place SW2 SW1
LM2 Louver motor（Left）
SM
Indoor unit address:ones place
Indoor unit address:tens place Stepping motor（For electronic expansion valve）
LM3 Louver motor（Right）
BK Black
Blue
Color Marks
BL
Mark Color
RedRD
WH White
YE Yellow
YE／GN Yellow／Green
BrownBR
OR Orange
PinkPK
Mark Color
LM1 LM2 LM3
FMi
（Remote operation input
（20S）
（SVH）
（SVG）
（SVE）
:volt-free contact）
For heat recovery
3-pipe systems
Thi-R3Thi-R2Thi-R1 Thi-A
Prepare on site
（Thermo ON）
（Operation）
（Inspection）
（Heating）
（Remote operation input
:volt-free contact）
HS
SM
Remote control
Thc
Connector for branching control of heat recovery 3-pipe systems
Power source
line
Earth
Power source line
between indoor units
Signal line
between indoor units
Signal line
（
Shielded cord
）
A
PHA001Z107