'17 • KX-T-264
2. Remove the expansion valve connector of the indoor unit and then connect the wiring of EEV-SET to the
CNA (PWB).
1) Check if the indoor unit is turned off and then connect the wiring of EEV-SET.
2) Wiring should be xed correctly so that any tension does not be put on the connector.
<Coil wiring route of EEV-SET >
① Remove CNA connector （Red）
② Connect coil wiring of EEV-SET to CNA (Red)
③ Removed connector wiring is stored in the control box.
②
①
Indoor unit
PWB
CNA(Rad,6P)
Type 22-56
Type 71-90
Coil wiring of EEV-SET
Coil wiring of EEV-SET
CNA(Rad,6P)
Removed
CNA connector
Removed
CNA connector
The allowable temperature of EEV-SET wiring is 105℃.
Change to heat-resistant wiring at locations exceeding 105℃
Do not fix the wiring to the pillar or board by staple directly, which causes damage to the wiring in long term use.
!
–
125
–
To Next Page
Loading...
