'17 • KX-T-264
-
71-1
-
E11
Address setting error between
master and slave indoor units
Keeps flashing Keeps flashing
1.Applicable model
5. Troubleshooting
All models
Diagnosis Countermeasure
• In cases of RC-E5
Return address No. to
“IU
…
” using [
▲
] or
[
▲
] button.
• In cases of RC-EX3
Menu
Next
IU settings
Select IU
2. Error detection method
IU address has been set using
the “Master IU address set”
function of remote control.
3.
Condition of error displayed
Same as above
4. Presumable cause
Same as above
Note:
Is “Master IU
address set” function of remote
control used?
E11 occurs
YES
Error code
Remote control:
LED Green Red
Indoor
Content
IU IU IU
R/C
In case the wiring is below and “Master IU address
set” is used, E11 is appeared.
Error code
Remote control:
LED Green Red
Indoor
Outdoor
Content
E11
Address setting error between
master and slave indoor units
Keeps ashing
Stays OFF
Keeps ashing
Stays OFF
–
97
–
To Next Page
Loading...
