13-20 Useful advice for emergencies
CAUTION
• If you replace the headlamps yourself, have
an authorized dealer perform aiming adjust-
ments as soon as possible.
• Do not disturb the settings of the aiming
adjustment screws. Doing so alters the
directional focus of the headlamps and this
could be hazardous to approaching motor-
ists.
2 Replacing of parking lamp
1. Tilt the cab.
2. Remove the socket by turning it counterclock-
wise.
3. Remove the bulb by pulling it out.
4. Install the lamp by following the above steps in
reverse.
5. Clean the packing if dirty.
3 Replacing front turn signal lamp
1. Open the front panel. P. 12-4
2. Remove socket by turning it counterclock-
wise.
3. Push bulb and turn counterclockwise to
remove it.
4. Install the lamp by reversing the order of
removal.
5. If the packing is dirty, clean it.
4 Replacing front side turn signal lamp
<FK61F>
1. Push the bottom of the lamp rearward to release
the tab . Then remove the lamp unit.
2. Turn the socket counterclockwise and
remove it.
3. Remove the bulb by pressing it and turning it
counterclockwise. Then, fit a new bulb.
4. Refit the lamp unit in the vehicle body by fitting
the clip first and then pressing lightly the tab
into place.
After installation, make sure that the lamp unit is
securely retained.
5. If the packing is dirty, clean it.
Z13642
Z17497
Z13648
FKFM.book Page 20 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
