5-30 Switches and controls
Main switch
This switch is used to activate and deactivate
the cruise control function. The lamp inside the
switch illuminates when the cruise control is on.
The switch will return to the neutral position
when you release it.
Cancel switch
Used to terminate cruise-control operation.
SET/RESUME switch
SET position:
Used to set a desired speed and to reduce the
set speed.
RESUME position:
Used to increase the set speed and to return to
a previously memorized speed.
Cruise control indicator lamp
If the cruise control is activated, this lamp illumi-
nates during driving.
NOTE:
The indicator lamp will light up when the starter
switch is turned to the “ON” position and the engine
is not running. It will go out in a few seconds if there
are no problems.
1 To set a desired speed
1. Check that the exhaust brake switch is in the
OFF position. If the switch is in the ON position,
place it in the OFF position.
Press the ON side of the main switch. The lamp
inside the switch will illuminate.
WARNING
For safety, turn off the main switch when the
cruise control is not in use.
Z17282
Z17283
FKFM.book Page 30 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
