5-31
2. Depress the accelerator pedal until the desired
speed is reached.
3. When the desired speed is reached, turn the
“SET/RESUME” switch to the “SET” position.
The indicator lamp will illuminate indicating
that the cruise control is activated. Now the
desired speed is memorized, so release the
accelerator pedal. The vehicle will run maintain-
ing that speed automatically.
NOTE:
• When setting the desired speed, the gearshift
lever in a manual transmission vehicle must be
in the 4th or higher gear position and in an auto-
matic transmission vehicle, the selector lever
must be in the “D” position.
• Before pressing the ON side of the main switch
to set a desired speed, make sure the exhaust
brake switch is in the OFF position. You will not
be able to set the speed if the exhaust brake
switch is in the ON position. When driving with
the cruise control active, exhaust braking can be
used as usual, but the cruise control function will
be deactivated while exhaust braking is being
used.
2 To increase the set speed in cruise con-
trol mode
•
By using the resume switch
Turn the “SET/RESUME” switch to the “RESUME”
position. The vehicle will accelerate. When the
desired speed is reached, release the switch. The
vehicle will cruise at the new, higher speed.
Z11829
Z17641
Z11831
FKFM.book Page 31 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
