Why does Mitsubishi Lcd projector show red, blue, and green dots?
The appearance of red, blue, and green dots, or black dots, in projected images from your Mitsubishi Lcd projector is unique to LCD projectors and isn’t a malfunction. A small number of pixels may always stay on or off, which are not malfunctions. More than 99.99% of the pixels are effective.
Why does Mitsubishi HC6500 Lcd projector have afterimages persist on the screen?
If afterimages persist on the screen of your Mitsubishi Lcd projector, this can be improved by continuously projecting an evenly dark image.
How to fix blurred images on Mitsubishi HC6500 Lcd projector?
To fix blurred images on your Mitsubishi Lcd projector, adjust the focus. Clean the lens. You can also press the W or X button on the remote control to eliminate flicker. Additionally, adjust TRACKING and FINE SYNC in the SIGNAL menu, and adjust BRIGHTNESS and CONTRAST in the IMAGE menu. Ensure the projector and screen are perpendicular to each other.
How to brighten dark images on Mitsubishi HC6500?
To brighten dark images on your Mitsubishi Lcd projector, adjust the BRIGHTNESS and CONTRAST in the IMAGE menu. If the issue persists, consider replacing the lamp.
How to fix distorted images on Mitsubishi HC6500 Lcd projector?
To correct distorted images on your Mitsubishi Lcd projector, adjust the projector and the screen so that they are perpendicular to each other.
How to fix shaking images on Mitsubishi HC6500 Lcd projector?
To fix shaking or displaced images on your Mitsubishi Lcd projector, first check that the cable connected to the external device isn’t intermittent and connect the cable’s plug firmly. Then, press the AUTO POSITION button. If the issue persists, it may be due to the computer outputting out-of-spec signals; in this case, adjust the SIGNAL menu settings.
What to do if Mitsubishi HC6500 Lcd projector says 'no signal'?
If your Mitsubishi Lcd projector displays “NO SIGNAL”, first turn on the connected device and ensure it is functioning correctly. Verify the external device is outputting signals, especially if it’s a notebook computer. Check the cable connecting the projector to the external device for any defects, and ensure the projector is connected using the correct terminals. Confirm that the connected device is correctly selected as the input source. If using an extension cord, replace it with the supplied cable to check if images are projected correctly; if they are, use an RGB signal amplifier with the extension cord.
Why does Mitsubishi HC6500 power turns off?
Your Mitsubishi Lcd projector might be turning off because the intake vent and/or exhaust vents are blocked. Remove any obstructions, wait for the fan to stop (until the STATUS indicator goes out), unplug the power cord, wait at least 10 minutes, plug it back in, and press the POWER button. If the STATUS indicator is steady red, the lamp needs replacing. Check that AUTO POWER OFF is set to OFF. It's also possible the lamp is deteriorating and may go out after a while.
General| Brand | Mitsubishi |
|---|---|
| Model | HC6500 |
| Category | Lcd projector |
| Language | English |
To Next Page