l
4)
POSITION LOOP OFFSET AND DROOP ADJUSTMENTS
Item
Adjustment
Remarks
Offset
1 Display screen 5 with ALARM/DIAGNOSIS
adjust-
c.ontrol
at NC side.
.?
(With
MQ)
ment
2 Check that NC READY signal appears.
3 Adjust VR7 on AC transistor ampli-
fier and set POSITION DROOP to +/-2.
Droop
1 Display screen 5 with ALARM/DIAGNOSIS
adjust-
control at NC side.
--;
_
.:
nent
2 Check that detector being used and
l
name of detector on screen tally.
3 Check that TAU and LINEAR ZONE are
correct.
l
4 Calculate position droop from formula
below:
Feedrate
(mm/min)
x 1
x
2
60
gain
Feedrate
is
Fl000
(approx. 100 rpm
motor speed)
0
5 Feed axis 1 so that position droop is
Remember that
made
(+I
and use VR2 on AC transistor
this differs
amplifier to adjust to position droop
from machine's
in
(4).
(+I
(-1
direc-
tions.
‘.
0
-390
To Next Page
Loading...
