l
0
0
4)
Installation method
(1)
Install the O-ring
(S75)
to the
sensor flange.
(2)
Install an M4 hexagonal bolt with
hole to the coupling.
(3)
Align the motor shaft key with key
groove in the sensor bellows
(4)
Align the sensor positioning mark
with the motor mark off line.
(5)
Install the sensor to the motor
(using
M5xO.8
screws).
(6)
Tighten the screw on the key groove
to secure the key so that it cannot
move.
(7)
Insert the sensor rubber plug
Note:
The bellows should not be detached from the detector
since the positions ofthesetwoparts
standin
a precise
relationship.
0
-43-
To Previous Page
Loading...
