Before operation: Insert the power supply plug into the power outlet and/or
turn the breaker on.
Installing the remote controller batteries
4, PressRESET "_LI .-_--_-_¢_
, Remove thll_o____
_ Insert AAA
alkaline batteries
_1_ 3_ Install the front lid
Make sure the polarity of the batteries is correct.
Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
Do not use rechargeable batteries.
Replace all batteries with new ones of the same type.
Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Setting current time
1, Press CLOCK
Press CLOCK again
Press the TIME buttons to set
the time
Each press increases/decreases
the time by I minute (t0 min-
utes when pressed longer)
Press CLOCK gently using a thin instrument.
Changing temperature units (°F--+°C)
Unit is preset with °F.
]" • Press RESET while
the temperature but-
tons are pressed.
• Press RESET gently using a thin instrument.
To change temperature unit from °C to °F, press RESET.
II
En-4
To Next Page
Loading...
