12
Ice
Server
Ice Tray
Reference Line
Sensor Lever
(Detects the
ice storage
level)
Ice Storage
Box
Door
Lay fl at
Remove the water tank from the refrigerator compartment,
remove the tank cap
by twisting it,
and supply water.
Do not pour water above the full position (
).
Water will easily spill when you carry the tank.
Further, it may cause the ice to join together or form a
protrusion.
*WARNING-Fill with potable water only.
Push in the water tank until it touches the rear side.
Setting the water tank incorrectly may prevent ice from forming.
Hold the tank with
both hands.
Push the tank until it
touches the rear side.
Close the water tank cap and return the water tank to its
original position.
Making Ice
Water
Supply
Port
When a door is open,
you will be informed
with the door alarm.
Page 32
Lid
Tank Cap
Ice Tray
Water Tank
(About 1.2L)
Ice Storage
Box
Ice Tray Lock Lever
Push in the water tank until it touches
the rear side and confi rm that the handle
is aligned with the front of the lower
case.
If water is put into the refrigerator compartment's water tank, ice will be
made in the ice making compartment.
Clean the ice maker periodically to ensure that the ice is pure and
delicious.
Pages 26 - 27
Wash the water tank, water supply pipe, and ice tray before making ice for the fi rst time, or if you have
not made ice for more than a week.
Ice Making Compartment
Ice
Server
Ice Storage
Box
Compartment Introduction
Lower Case
Full position (
)
1
2
Soundproof Mat
Reduces the sound of dropping
ice. Do not dispose of it.
Set the ice making compartment to "STOP" mode when storing food in it.
Store food lower than the reference line of the ice storage box (otherwise
it may cause an ajar door, malfunction or damage).
Pages 21 - 22
Do not pour anything other than cold water into the water tank, such as
warm water, juice, tea, soft drinks, or other liquids (the tank can resist
heat up to 60°C).
Pouring anything other than cold water into the tank may cause damage.
Do not pour water directly into the ice tray to make ice. Unfrozen water in the ice
tray may fall into the ice storage box, and the ice may join not forming cubes.
Do not place objects at the rear of the ice storage box.
The level of the ice storage is checked automatically by the sensor
lever, and ice making is stopped when the ice reaches a certain level
(about 70 to 140 ice cubes). To detect the ice storage level correctly,
make sure that the ice is fl at and that the ice server is kept in its storage
position in the front of the ice storage box as shown in the left diagram.
Tips
To Next Page
Loading...
Need help?
General
