9
2.Immobilization / stabilization / lifting
1. How to determine if vehicle is ON / OFF.
The operating range is the interior of the vehicle.
OFF
Check that the illumination of the "indicator lamp" and "combination meter" is off.
ON
The indicator lamp on the electric motor switch illuminates blue.
The indicator light illuminates for a few seconds and goes off when the Plug-in Hybrid EV System is operating.
When the electric motor switch is “ON”, “combination meter” light up.
If you press the electric motor switch without pressing the brake pedal while the vehicle is stationary, you can
change the operation mode in the order of “OFF”, “ACC”, “ON”, “OFF”.
READY Indicator
The READY indicator keeps flashing until Plug-in Hybrid EV System is activated.
When the Plug-in Hybrid EV System has activated normally and the vehicle becomes ready to run, the lamp stops
flashing and stays lit.
The driver can start driving when the READY indicator lit.
2. Support positions for Jack and Lift
CAUTION:
- Be sure to support the specified locations only. Otherwise, deformation of vehicle may occur.
○:Support position for Garage Jack ○:Support position for Jack or Axle stands or Lift.
Front suspension crossmember
Rear suspension crossmember
To Next Page
Loading...
Need help?
General
