11
How to Stabilize a rollover or an overturned vehicle
CAUTION:
- Use a support that is strong enough.
- When installing prop tools, avoid exhaust systems, fuel systems, high-voltage parts, high-voltage harnesses, etc.
- If the inside of the high-voltage components or the high-voltage harness is exposed, avoid the exposed parts when
installing.
・Stabilization method for prop tools of rollover vehicle
Please support the prop tools on the vehicle roof or the vehicle bottom. Depending on the situation, support the prop
tools with 2, 3, or 4 to stabilize it.
・Stabilization method using blocks, etc. of rollover vehicle
If needed to up the vehicle, use a spreader or jack, etc., and place supports such as blocks in the gap to stabilize it.
・Stabilization method using wheel stoppers, blocks, props, etc. of overturned vehicle
Blocks or wheel stoppers are set up in the gap between the hood and pillars to stabilize the vehicle.
When to increase the stability, place a column at the rear of the vehicle (a strong place) to stabilize it.
To Next Page
Loading...
