To enter frequencies into the memory (AM/FM/SAT)
1. Press to turn on the audio system.
2. Press to select the desired band (AM/FM/SAT).
3. Press to Seek Station.
4. Hold down one of the Memory select buttons
(1-6) until it beeps in order to save that station to
memory.
To adjust the clock
1. Press and hold the PAGE key and the clock
display flashes.
2. Press the various buttons shown just above to adjust:
H- “Hour” setting.
Press this key to fast-forward the “hours”
M- “Minutes” setting.
Press this key to fast-forward the “minutes”
3. Press the PAGE key to finish adjusting the
time. When the adjustment is completed, the clock
display stops flashing.
Audio Remote Control Switch
VOLUME
UP
VOLUME
Down
SEEK
Change
station
or track
MODE
Change
the
audio
source
A
B
C
C
D
USB and iPod
®
Input
1. Park your vehicle in a safe place and turn the
ignition switch to the “OFF” position or put the
Operation Mode in OFF.
2. Plug in the USB connecting cable that is supplied
with your device and connect the USB end into the
input terminal located in the floor console box.
3. Turn the ignition switch or the Operation Mode to
the “ACC” position. Turn on the audio system.
4. Press MEDIA to switch to the USB mode.
The input mode changes as follows:
5. Depending on your USB device, it may take longer
for playback to start.
6. Once the device is selected, playback starts.
With Display Audio System, follow steps 1 through 3 above
4. Press MENU on the touch screen.
5. Touch USB.
6. Touch <Folder> then select a track and begin
playback.
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
C
D
B
A
NOTE: Please refer to your Owner’s Manual for more
detailed information on how to use your audio
system.
11
AUDIO SYSTEM
Audio System
To Next Page
Loading...
