The sunshade can be operated with the ignition switch or the
operation mode in ON.
- Pull the switch in the arrow direction to open the sunshade.
Pulling the switch all the way automatically opens the sunshade
completely.
- Push the switch in the arrow direction to close the sunshade.
Pushing the switch all the way automatically closes the sunshade
completely.
- Push the switch up to stop the moving sunshade. If an object
obstructs the sunshade from closing, the safety mechanism will
cause the sunshade to re-open automatically. The opened
sunshade will become operational again after a few seconds.
- The sunshade illumination turns on with the ignition switch or
when the operation mode is in ON or ACC.
• Push the switch to change brightness of the sunshade
illumination. The brightness switches in sequence from
High → Middle → Low → Off → High.
A
B
C
D
Panoramic Sunshade (if equipped)
B
C
D
A
To defog front windshield (for both automatic and manual)
1. Set the Mode Dial to defrost position.
2. Set the blower speed to the maximum position.
3. Set the temperature to the highest position.
D
A
B
C E
F
A
B
C
D
E
F
E
C
A
Automatic Climate Controls
- Turn for temperature control.
- Push to select outside air (Indicator light off) or
recirculated air (Indicator light on).
- Turn to select the blower speed. To the right
increases blower speed. To the left decreases blower
speed. Turned all the way to the left turns the blower
off. Note: OFF is located above AUTO.
- Push for air conditioning ON/OFF (Indicator light on/
Indicator light off).
- Turn to select the air flow and direction mode.
- Push to defog the rear window (Indicator light on).
Rear window defogger light automatically turns off
after 20 minutes.
CONTROLS
6
Seat Heater Switch (if equipped)
1
2
3
2
3 1
1
2
3
HI - For quick heating
- Heater off
LO - To keep the seat warm
To Next Page
Loading...
