© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
12 (244)12 (244)
PBV20N2 PBV20N2 Service Service ManualManual
3
3 Safety Safety instructionsinstructions
WARNINGWARNING
The proper and safe lubrication and maintenance of these lift The proper and safe lubrication and maintenance of these lift trucks as recommendedtrucks as recommended
by the manufacturer is outlined in this document. Read by the manufacturer is outlined in this document. Read this manual before performingthis manual before performing
any lubrication or maintenance on these trucks. Improper performance of lubrication orany lubrication or maintenance on these trucks. Improper performance of lubrication or
maintenance procedures is dangerous and can result in injury or maintenance procedures is dangerous and can result in injury or death.death.
Do not make any alterations or Do not make any alterations or repairs that can weaken the truck’s structure orrepairs that can weaken the truck’s structure or
endanger safety.endanger safety.
Do not operate the truck unless you Do not operate the truck unless you have read and understood the instructions in thehave read and understood the instructions in the
operator manual. Improper truck operation is dangerous and can result in injury oroperator manual. Improper truck operation is dangerous and can result in injury or
death.death.
Knowledge of the system and/or its components is Knowledge of the system and/or its components is important before the removal orimportant before the removal or
disassembly of any components.disassembly of any components.
.
.
The following sections list The following sections list some basic precautions that should always some basic precautions that should always be observed.be observed.
3.13.1
Service area safetyService area safety
•
•
Keep the service area clean. Oil, grease, and water Keep the service area clean. Oil, grease, and water make the floor slippery.make the floor slippery.
•
•
If possible, make all repairs with If possible, make all repairs with the truck parked on a the truck parked on a level, hard surface.level, hard surface.
•
• Before starting to work on Before starting to work on the truck, hang a "Do the truck, hang a "Do not Operate" sign in the operatornot Operate" sign in the operator
compartment.compartment.
••
The truck must always be supported on jacks, The truck must always be supported on jacks, if working underneath it.if working underneath it.
•
•
Do not work on any truck that is Do not work on any truck that is supported only by lift jacks or a hoist. Always usesupported only by lift jacks or a hoist. Always use
blocks or jack sblocks or jack stands to support the truck before performing any disassembly.tands to support the truck before performing any disassembly.
•
•
Lower the forks or Lower the forks or other implementother implements to the s to the ground before performinground before performing any work ong any work on
the truck. If this cannot be done, make sure the forks or other implements arethe truck. If this cannot be done, make sure the forks or other implements are
blocked correctly to prevent blocked correctly to prevent them from falling unexpectedly.them from falling unexpectedly.
•
• Use steps and grab handles (if applicable) when mounting or dismounting a truck.Use steps and grab handles (if applicable) when mounting or dismounting a truck.
Clean any mud or debris from Clean any mud or debris from steps, walkways or work steps, walkways or work platforms before use.platforms before use.
Always face the trucAlways face the truck when using k when using steps, ladders asteps, ladders and walkways. Whnd walkways. When it is noten it is not
possible to use the designed access system, use ladders, scaffolds, or possible to use the designed access system, use ladders, scaffolds, or workwork
platforms to perform safe platforms to perform safe repair operations.repair operations.
To Next Page
Loading...
Need help?
General
