© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
15 (244)15 (244)
PBV20N2 PBV20N2 Service Service ManualManual
•
• Loose or damaged fuel, lubricant and hydraulic lines, tubes and hoses can causeLoose or damaged fuel, lubricant and hydraulic lines, tubes and hoses can cause
fires. Do not bend or fires. Do not bend or strike any high pressure lines or strike any high pressure lines or install ones that have beeninstall ones that have been
bent or damaged. Inspect all lines, tubes and hoses carefully. Pin hole (very bent or damaged. Inspect all lines, tubes and hoses carefully. Pin hole (very small)small)
leaks can result in a high velocity oil stream that will be invisible close to the hose.leaks can result in a high velocity oil stream that will be invisible close to the hose.
This oil can penetrate the skin and cause personal injury, so This oil can penetrate the skin and cause personal injury, so use cardboard oruse cardboard or
paper to locate pin hole leaks.paper to locate pin hole leaks.
•
•
Tighten connectioTighten connections to the correct ns to the correct torque. Make sure that all heat shields, clampstorque. Make sure that all heat shields, clamps
and guards are installed correctly to avoid excessive heat, vibration or and guards are installed correctly to avoid excessive heat, vibration or rubbingrubbing
against other parts during operation. Protective shields against oil against other parts during operation. Protective shields against oil sprays onto hotsprays onto hot
exhaust componeexhaust components in the event of nts in the event of a line, tube or a line, tube or seal failure must be installedseal failure must be installed
correctly.correctly.
•
•
Do not operate the truck, Do not operate the truck, if any rotating part is if any rotating part is damaged or comes into contact withdamaged or comes into contact with
any other part during operation. Every high speed rotating component that has beenany other part during operation. Every high speed rotating component that has been
damaged or altered should be checked for balance before reusing.damaged or altered should be checked for balance before reusing.
To Next Page
Loading...
Need help?
General
