Mitsubishi PBV20N2 - Page 150

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
149 (244)149 (244)



PBV20N2 PBV20N2 Service Service ManualManual
PARAMETER DESCRIPTION
PARAMETER DESCRIPTION
Turtle cutback speed reductionTurtle cutback speed reduction
TURTLE CUTBACKTURTLE CUTBACK
This parameter controls the speed reduction whenThis parameter controls the speed reduction when
the low speed mode is activated.the low speed mode is activated.
Value range:Value range:
•
•
 10%: Enabled10%: Enabled
•
•
 100%: Disabled100%: Disabled
Walkie mode cutbackWalkie mode cutback
WALKING CUTBACKWALKING CUTBACK
This parameter controls the maximum speed in theThis parameter controls the maximum speed in the
pedestrian mode.pedestrian mode.
Value range:Value range:
•• 10%: Slowest10%: Slowest
•
• 100%: Fastest100%: Fastest
Table 7. Submenu: adjustmentsTable 7. Submenu: adjustments
PARAMETER DESCRIPTION
PARAMETER DESCRIPTION
Adjust battery voltageAdjust battery voltage
ADJUST BATTEADJUST BATTERYRY
Because the traction motor controller monitors theBecause the traction motor controller monitors the
battery discharge level, this parameter must be setbattery discharge level, this parameter must be set
to match the actual battery voltage. The to match the actual battery voltage. The differencedifference
between the ADJUST BATTERY VALUE parameterbetween the ADJUST BATTERY VALUE parameter
value and the voltmeter reading should be value and the voltmeter reading should be ±0.2 V.±0.2 V.
Connect the voltmeter between –Batt and key inputConnect the voltmeter between –Batt and key input
K1/1. Use a high-quality voltmeter to check theK1/1. Use a high-quality voltmeter to check the
battery voltage and set this parameter as close tobattery voltage and set this parameter as close to
the meter reading as possible. This measurementthe meter reading as possible. This measurement
can be carried out at can be carried out at any time (i.e. regardlessany time (i.e. regardless
whether the battery is full or whether the battery is full or empty).empty).
This parameter should be set after the This parameter should be set after the controller hascontroller has
been changed or if been changed or if there are problems with batterythere are problems with battery
charge level monitoring.charge level monitoring.
Battery maximum value adjustBattery maximum value adjust
BAT MAX ADJ.BAT MAX ADJ.
This parameter controls the maximum level forThis parameter controls the maximum level for
charged battery.charged battery.
Value range:Value range:
•
• Level = 0: MinimumLevel = 0: Minimum
•• Level = 9: MaximumLevel = 9: Maximum
Battery minimum value adjustBattery minimum value adjust
BAT. MIN ADJ.BAT. MIN ADJ.
This parameter controls the minimum level forThis parameter controls the minimum level for
discharged battery.discharged battery.
Value range:Value range:
•
•
 Level = 0: MinimumLevel = 0: Minimum
•
• Level = 9: MaximumLevel = 9: Maximum
BDI startup correction valueBDI startup correction value
BDI ADJ STARTUPBDI ADJ STARTUP
At startup, the BDI is cAt startup, the BDI is calculated with this voltagealculated with this voltage
adjust parameter.adjust parameter.
Value range:Value range:
•• Level = 0: MinimumLevel = 0: Minimum
•
•
 Level = 9: MaximumLevel = 9: Maximum
https://www.forkliftpdfmanuals.com/