Mitsubishi PBV20N2 - Page 151

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
150 (244)150 (244)



PBV20N2 PBV20N2 Service Service ManualManual
PARAMETER DESCRIPTION
PARAMETER DESCRIPTION
Check up doneCheck up done
CHECK UP DONECHECK UP DONE
Maintenance request acknowledgement.Maintenance request acknowledgement.
Check up typeCheck up type
CHECK UP TYPECHECK UP TYPE
•
•
 0 = No maintenance warnings.0 = No maintenance warnings.
•
• 1 = Maintenance warning in 600 h.1 = Maintenance warning in 600 h.
•• 2 = Maintenance warning in 600 h, speed2 = Maintenance warning in 600 h, speed
reduction in 640 h.reduction in 640 h.
•
• 3 = Maintenance warning in 600 h, speed3 = Maintenance warning in 600 h, speed
reduction in 640 h, truck stop in 680 h.reduction in 640 h, truck stop in 680 h.
Electrobrake retain voltageElectrobrake retain voltage
EB VOLTAGE RED.EB VOLTAGE RED.
This parameter controls the brake coil voltage oneThis parameter controls the brake coil voltage one
second after the activation of the second after the activation of the brake voltage. Thebrake voltage. The
parameter should be set between 60% and 80%.parameter should be set between 60% and 80%.
Value range:Value range:
•
• 0%: Minimum0%: Minimum
•• 100%: Maximum100%: Maximum
Fan start temperatureFan start temperature
FAN FAN TEMPERATURETEMPERATURE
This parameter controls the temperature limit forThis parameter controls the temperature limit for
fans. If any of the fans. If any of the measured temperatures exceedmeasured temperatures exceedss
this value, the fans are started.this value, the fans are started.
Main contactor retain voltageMain contactor retain voltage
MC VOLTAGE RED.MC VOLTAGE RED.
This parameter controls the main contactor coilThis parameter controls the main contactor coil
voltage one second after the activation of voltage one second after the activation of the mainthe main
contactor voltage.contactor voltage.
Value range:Value range:
•
•
 0%: Minimum0%: Minimum
•
• 100%: Maximum100%: Maximum
Maximum lifting timeMaximum lifting time
MAX LIFT TIMEMAX LIFT TIME
Maximum lift time adjustment.Maximum lift time adjustment.
•
• Level = 3: MinimumLevel = 3: Minimum
•
• Level = 15: MaximumLevel = 15: Maximum
Throttle 0 zoneThrottle 0 zone
THROTTLE 0 ZONETHROTTLE 0 ZONE
This parameter establishes the dead band in This parameter establishes the dead band in thethe
finger tip input curve (seefinger tip input curve (seeFigure 86Figure 86 below).below).
Throttle curve X-axisThrottle curve X-axis
THROTTLE X POINTTHROTTLE X POINT
This parameter changes the characteristics of theThis parameter changes the characteristics of the
finger tip input curve (seefinger tip input curve (seeFigure 86Figure 86 below).below).
Throttle curve Y-axisThrottle curve Y-axis
THROTTLE Y POINTTHROTTLE Y POINT
This parameter changes the characteristics of theThis parameter changes the characteristics of the
finger tip input curve (seefinger tip input curve (seeFigure 86Figure 86 below).below).
https://www.forkliftpdfmanuals.com/