© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
48 (244)48 (244)
PBV20N2 PBV20N2 Service Service ManualManual
5.6.1 5.6.1 Replacing Replacing the the operator’s operator’s platform platform gas gas springspring
The gas spring of the The gas spring of the operator’s platform can be replaced either with the platform inoperator’s platform can be replaced either with the platform in
place or with the place or with the platform removed compleplatform removed completely from the truck tely from the truck frame. Instructions forframe. Instructions for
replacing the operator’s platform gas spring are provided below, but the samereplacing the operator’s platform gas spring are provided below, but the same
instructions can be applied also while working with the platform removed.instructions can be applied also while working with the platform removed.
1.1. Remove the rubber mat from theRemove the rubber mat from the
operator’s platform by pulling it fromoperator’s platform by pulling it from
one corner.one corner.
2.2. Lift the operator’s platform up.Lift the operator’s platform up.
3.3. Open the locking spring using aOpen the locking spring using a
screwdriver. Also remove the ballscrewdriver. Also remove the ball
joint if needjoint if needed.ed.
To Next Page
Loading...
