Mitsubishi PBV20N2 - Page 49



© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
49 (244)49 (244)

PBV20N2 PBV20N2 Service Service ManualManual
4.4. Carefully lower the operator’sCarefully lower the operator’s
platform.platform.
5.5. Pull the gas spring out through thePull the gas spring out through the
hole in the hole in the operator’s platform.operator’s platform.
6.6. Push the new spring into place,Push the new spring into place,
making sure that the spring’s head ismaking sure that the spring’s head is
positioned correctly into the slotpositioned correctly into the slot
inside the operator’s platform.inside the operator’s platform.
7.7. Carefully lift the operator’s platform, making sure that the new Carefully lift the operator’s platform, making sure that the new spring does not fallspring does not fall
out.out.
8.8. Tighten the gas spring locking spring and install the ball joint if Tighten the gas spring locking spring and install the ball joint if it was rit was removedemoved
earlier.earlier.
9.9.
Lower the operator’s platform.Lower the operator’s platform.
10.10.
Attach the rubAttach the rubber mat to the ober mat to the operator’s platperator’s platform.form.
https://www.forkliftpdfmanuals.com/