Mitsubishi PBV20N2 - Page 53



© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
53 (244)53 (244)

PBV20N2 PBV20N2 Service Service ManualManual
Figure 34. Traction wheel overviewFigure 34. Traction wheel overview
Check the wear of Check the wear of the traction wheel:the traction wheel:
•
• When the traction wheel’s diameter reaches 220 mm, adjust the castor wheels asWhen the traction wheel’s diameter reaches 220 mm, adjust the castor wheels as
instructed in sectioninstructed in section5.12.2.5.12.2.
•• When the traction wheel’s diameter reaches 214 When the traction wheel’s diameter reaches 214 mm, replace the traction mm, replace the traction wheelwheel
and adjust the castor wheels as instructed in and adjust the castor wheels as instructed in sectionsection5.12.2.5.12.2.
5.9.1 5.9.1 Disassembly Disassembly of of the the traction traction wheelwheel
1.1. Remove the five rounded cone nutsRemove the five rounded cone nuts
holding the traction wheel in place.holding the traction wheel in place.
2.2. Remove the traction wheel.Remove the traction wheel.
3.3. Check the condition of the wheelCheck the condition of the wheel
shaft bolts. Replace the bolts, ifshaft bolts. Replace the bolts, if
needed. For instructions, see theneeded. For instructions, see the
sectionsection5.9.1.15.9.1.1 below.below.
https://www.forkliftpdfmanuals.com/