© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
58 (244)58 (244)
PBV20N2 PBV20N2 Service Service ManualManual
Disassembly of the linkage mechanism:Disassembly of the linkage mechanism:
1.1. On the wheel fork side, rOn the wheel fork side, remove theemove the
tub pin from the load wheel forktub pin from the load wheel fork
shaft.shaft.
2.2. Remove the load wheel fork shaft.Remove the load wheel fork shaft.
3.3. On the linkage mechanism’s forkOn the linkage mechanism’s fork
carriage side, open the screw fromcarriage side, open the screw from
the fork carriage shaft.the fork carriage shaft.
4.4. Screw a bolt (size M8) onto theScrew a bolt (size M8) onto the
threads at the end of the forkthreads at the end of the fork
carriage shaft and use a slide pullcarriage shaft and use a slide pull
hammer to pull the shaft out.hammer to pull the shaft out.
5.5. On the chassis side of On the chassis side of the linkagethe linkage
mechanism, open the screw of themechanism, open the screw of the
chassis shaft.chassis shaft.
6.6. Remove the chassis shaft.Remove the chassis shaft.
7.7. Remove the tub pin from push rodRemove the tub pin from push rod
shaft.shaft.
8.8. Remove the push rod shaft.Remove the push rod shaft.
To Next Page
Loading...
