Mitsubishi PBV20N2 - Electric system maintenance; Tiller arm



© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
85 (244)85 (244)

PBV20N2 PBV20N2 Service Service ManualManual
8
8 Electric Electric system system maintenancemaintenance
8.18.1
Tiller armTiller arm
Figure 49. Tiller arm overviewFigure 49. Tiller arm overview
1.1. Tiller headTiller head
2.2. Tiller head switchesTiller head switches
3.3. Safety buttonSafety button
4.4. AcceleratorAccelerator
8.1.1 8.1.1 Removing Removing the the tiller tiller headhead
CAUTIONCAUTION
Before opening the tiller head, turn the Before opening the tiller head, turn the key switch to the OFF position and key switch to the OFF position and disconnectdisconnect
the battery plug/connector. Record the places of the harness connections beforethe battery plug/connector. Record the places of the harness connections before
disassembly.disassembly.
When disconnecting the connector, hold the connector housing and plug and thenWhen disconnecting the connector, hold the connector housing and plug and then
unlock the connector. Holding the case may cause unlock the connector. Holding the case may cause damage to the inside card, whiledamage to the inside card, while
holding the cable may cause wire holding the cable may cause wire breakage.breakage.
https://www.forkliftpdfmanuals.com/