A - 21
CHAPTER6 BASE UNIT AND EXTENSION CABLE
6.1 Base Unit
6.1.1 Specification Table
6.1.2 Part Names
6.1.3 Setting the Extension Base Unit
6.1.4 Guideline for Use of Extension Base Units
6.2 Extension Cable
6.2.1 Specification Table
CHAPTER7 MEMORY CARD AND BATTERY
7.1 Memory Card
7.1.1 List of Usable Memory Cards
7.1.2 Memory Card Specifications
7.1.3 The Part Names of the Memory Card
7.1.4 Handling the Memory Card
7.1.5 Memory Card Loading/Unloading Procedures
7.1.6 Specifications of the Battery for Memory Card
7.1.7 Battery Installation into the Memory Card
7.2 Battery (Q6BAT, Q7BAT, Q8BAT)
7.2.1 Battery Specifications
7.2.2 Installation of Battery
CHAPTER8 CPU MODULE START-UP PROCEDURES
CHAPTER9 EMC AND LOW VOLTAGE DIRECTIVES
9.1 Requirements for Conformance to EMC Directive
9.1.1 Standards relevant to the EMC Directive
9.1.2 Installation instructions for EMC Directive
9.1.3 Cables
9.1.4 Power Supply Module and Q00JCPU's Power Supply Part
9.1.5 When Using MELSEC-A Series Modules
9.1.6 Others
9.2 Requirement to Conform to the Low Voltage Directive
9.2.1 Standard applied for MELSEC-Q series PLC
9.2.2 MELSEC-Q series PLC selection
9.2.3 Power supply
9.2.4 Control panel
9.2.5 Grounding
9.2.6 External wiring
CHAPTER10 LOADING AND INSTALLATION
10.1 General Safety Requirements
10.2 Calculating Heat Generation of PLC
10.3 Module Installation
10.3.1 Precaution on installation
To Next Page
Loading...
Need help?
General
