5 - 2 5 - 2
MELSEC-Q
5 SETTINGS AND PROCEDURES UP UNTIL OPERATION
5
5.2 Settings and Procedures Up Until Operation
A brief list of procedures up until operation of this module is shown below.
Start
Check the functions used and the
specifications.
Connect the external device and the
module with a cable.
Connect the GX Developer and QCPU
with a cable.
Perform all the settings with GX Developer.
Carry out programming.
Carry out debugging.
Set the run mode by the GX Developer.
• Connect the QD51 (-R24) and the external device.
• Refer to Section 5.5 of this manual.
• Set the QD51 (-R24)s Input / Output assignment.
• Carry out QD51 (-R24) mode setting (programming mode) and set operation.
• Refer to Section 5.6 of this manual.
End
• Commands and functions
• Refer to the programming manual (Commands).
Connect the console and the module with
cables.
• Connect the console/debugger.
• Refer to Section 5.4 of this manual.
• Carry out QD51 (-R24)s mode setting (Run mode/Multitask Debug mode)
and set operation.
• Refer to Section 5.6 of this manual.
REMARK
The transmission rate and data format are set using the BASIC program (ZOPEN
commands).
For details, refer to the Programming Manual (Commands).
To Next Page
Loading...
Need help?
General
