3 - 59 3 - 59
MELSEC-Q
3 SPECIFICATIONS
(b) If the program runs all the time
The program runs all the time if an END command is not used at the end of
the BASIC program, but instead a "GOTO" command is used to cause it to
jump to a specific line.
The task starts when the power is turned on or when there is a Reset, then
runs until the GOTO command, then since it jumps to the specified line, it
runs repeatedly between the specified line and the GOTO command.
GO TO
Power On Reset
BASIC
Program
Task with "START" set
in the start condition.
BASIC
Program
To Next Page
Loading...
Need help?
General
